Do you have a picture of it in the case? Pictures rule

Making some progress but still no joy.

I added an ethernet shield to an UNO, and I have it on the network and responding to ping. Yeah me!

I am unable to get it to recognize the radio. I get "check wires" in the serial monitor. I have triple checked the wires and tried several different radio chips and have added a 4.7 capacitor.
==>Question here: The IRQ post doesn't connect anywhere on the arduino, right? I noticed that is says to connect to pin 2 on the serial gw, but it is not mentioned in the ethernet gw.

I have also created the device in Vera. It shows "Lua Failure" on the device and I get a cannot send command in the message window at the top. Also, no Lib version is displayed.
==>Is this normal behavior because it can't communicate with the Radio, or do I have another issue here?

Any help is GREATLY appreciated!

Kind of what I figured. Plus, they have them at radio shack.

Thanks all. I will post my results later

Thanks all. Any thoughts on going with a "real" nano or shifting gears and going with ethernet gw? Cost is bout the same. Any upside either way?

Here is my serial config:

I think you are correct. I just noticed that there is no lib version in Vera which I understand to mean that it is not communicating with the Nano. I read in another thread that the Chinese knock offs don't work well as GW. I have tried a few different Nano's (all from Banggood.com) all with the same results. I guess I will have to try a non-knockoff unless anyone else has any ideas. I have deleted and recreated the device in Vera a few times.

that

First off, I just want to say: This is the most exciting project I have come across. I have a vera for home automation and just started playing with arduino. The possibilities are endless! Thanks so much to Hek!!

So here is where I am:

I am trying to setup a gateway and one temp sensor. Can someone point me in the right direction. I /think/ that they are communicating. See the 2 screenshots below. I have verified all the wires and also added a capacitor. I am using 2 Nanos and the 2.4 transcevers.

This is the scketch I am using for the senson: http://mysensors.org/build/humidity
Using the latest and greatest Serial GW sketch.

I have created the device in Vera but I can't get it to see the sensor.