Just a small question that i hope has a simple answer.
Can you at a sensor localy to the sensebender gateway ...

Trying to upload this sketch put i'm getting the following error

BedOccupancySensor:60: error: 'MySensor' does not name a type

 MySensor gw;

 ^

C:\Users\Repair Tech\Downloads\BedOccupancySensor\BedOccupancySensor.ino: In function 'void setup()':

BedOccupancySensor:100: error: 'gw' was not declared in this scope

   gw.begin(NULL, NODE_ID);

   ^

C:\Users\Repair Tech\Downloads\BedOccupancySensor\BedOccupancySensor.ino: In function 'void loop()':

BedOccupancySensor:204: error: 'gw' was not declared in this scope

         gw.send(msgRightOcc.set(occStateRight[4]));  // Send tripped value to gw

         ^

BedOccupancySensor:260: error: 'gw' was not declared in this scope

         gw.send(msgLeftOcc.set(occStateLeft[4]));  // Send tripped value to gw

         ^

exit status 1
'MySensor' does not name a type

For as far as I can tell the libs are installed correctly

Found the error.
Wiring diagram is incorrect
It's not 4 and 5 but A4 and A5

Trying this build but getting the following in the serial monitor

MPU init: 0
Free mem: 1144
AWI Orientation

PWR led on the sensor is on but not getting any readings