Posts made by FUZNUTS

@BulldogLowell Yes. I put one 4.7uf for the radio and one for the DHT22 with no change. Over two days I did get it to read the DHT22 once out of 1000 or so reads and that was with out any capacitors.. Reading every 5 seconds

@Salmoides 5v regulated into raw comes out 4.52v on vcc

these are all 5.5v 16mhz or at least that's what they say..lol
ill try leaving it set up on the gateway and see what happens with fingers crossed

This is my second humidity sensor.

I keep getting the same error.
Failed reading temperature from DHT
Failed reading humidity from DHT

1. I have tried 4 different DHT22 and even the one off my working Humidity sensor
2. I have tried 5 different mini pros with only my original working..
3. My original has a blue LED but the others were ordered in a ten pack and have red LED.
4. Some of the red LED mini pro will only connect @ 57600 while others and blue LED connect @ 115200
5. Changing the input pin for the DHT22 makes no difference.

Do I just have a bunch of bad Mini Pros or am I missing something?

I am always getting a missing (file not detected) stdarg.h library with the Ethernet gateway sketch on codebender but no compiling errors. Is there any where to download this file? Its not in the Ethernet gateway download either..