I have 4 Nano/NRF24 sensor nodes with NODE-ID's defined in the sketches.
They work just fine with a W5100 MQTT Gateway, all nodes are recognized and messages passed to the MQTT broker. However when I instead use a Raspberry Pi, configured as a MQTT gateway, only one of the nodes seems to be recognized. What do I need to do to have all nodes recognized (two sensor nodes have the same 105 NODE_ID)?
mysgw: TSF:MSG:READ,105-105-0,s=133,c=1,t=37,pt=2,l=2,sg=0:3
mysgw: Sending message on topic: my103gw-out/105/133/1/0/37
mysgw: TSF:MSG:READ,105-105-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
mysgw: TSF:MSG:BC
mysgw: TSF:MSG:FPAR REQ,ID=105
mysgw: TSF:CKU:OK,FCTRL
mysgw: TSF:MSG:GWL OK
mysgw: !TSF:MSG:SEND,0-0-105-105,s=255,c=3,t=8,pt=1,l=1,sg=0,ft=0,st=NACK:0
mysgw: TSF:MSG:READ,133-133-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
mysgw: TSF:MSG:BC
mysgw: TSF:MSG:FPAR REQ,ID=133
mysgw: TSF:CKU:OK,FCTRL
mysgw: TSF:MSG:GWL OK
mysgw: !TSF:MSG:SEND,0-0-133-133,s=255,c=3,t=8,pt=1,l=1,sg=0,ft=0,st=NACK:0
mysgw: TSF:MSG:READ,132-132-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
mysgw: TSF:MSG:BC
mysgw: TSF:MSG:FPAR REQ,ID=132
mysgw: TSF:CKU:OK,FCTRL
mysgw: TSF:MSG:GWL OK
mysgw: !TSF:MSG:SEND,0-0-132-132,s=255,c=3,t=8,pt=1,l=1,sg=0,ft=0,st=NACK:0
mysgw: TSF:MSG:READ,133-133-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
mysgw: TSF:MSG:BC
mysgw: TSF:MSG:FPAR REQ,ID=133
mysgw: TSF:CKU:OK,FCTRL
mysgw: TSF:MSG:GWL OK
mysgw: !TSF:MSG:SEND,0-0-133-133,s=255,c=3,t=8,pt=1,l=1,sg=0,ft=0,st=NACK:0
mysgw: TSF:MSG:READ,105-105-0,s=134,c=1,t=0,pt=7,l=5,sg=0:18
mysgw: Sending message on topic: my103gw-out/105/134/1/0/0