Hi!

Just built my first sensor yesterday with a arduino UNO. I am now picking components from E-bay. I'm noticing that there is a cheaper nano with CH340G chipset. Will they work just as well for me?

@gohan The development branch

Hi

I've setup a MQTT gateway on a raspberry pi 2. It communicates with Home assistant (hass.io) with a Mosquitto broker installed. Everything is running fine a few hours but then it crashes. This is the error message I get

The gateway config is this (hass.io is on 192.168.1.160). Tried with and without the irq-pin=15 setting.

./configure --my-transport=nrf24 --my-gateway=mqtt --my-controller-ip-address=192.168.1.160 --my-mqtt-publish-topic-prefix=mysensors-out --my-mqtt-subscribe-topic-prefix=mysensors-in --my-mqtt-client-id=mygateway1 --my-transport=nrf24 --my-rf24-irq-pin=15

Hi

I’m currently running mysensors gateway on my raspberry pie but would like to change to hass.io. What’s my best option here? Is it somehow possible to still run a gateway on the raspberry?

Hi!

Just built my first sensor yesterday with a arduino UNO. I am now picking components from E-bay. I'm noticing that there is a cheaper nano with CH340G chipset. Will they work just as well for me?