Engraving the PCB
https://www.youtube.com/watch?v=CyfzYnQ8BGI&feature=youtu.be

Drilling the PCB
https://www.youtube.com/watch?v=VYDVqSGmoBQ&feature=youtu.be

Software I use:

Designspark This do I use to draw the PCB and it's a free software.

Cambam is the software I use to produce G-code to my CNC. This is not free, but you can run up to 500 raws of code.

This is my vacuum table.

This is a finnished PCB, a serial gaway.

This is the finnished gatway up and running.

:)

Here is my CNC mill, when i mill PCB boards do I use a plastic sheet, and have an opening just for the PCB board. I also use a 60 degree engraving bit, and mill to a depth of 0,145mm. The vacuum table do mill of about 1 tenth of a mm, time to time so I know that it's 100% flat. No need to probe more than to find the top of the PCB
The spindle is 1kw aircold, so I can't run it below 6000rpm Max speed is 24 000 rpm.

A start of my wateringsystem for my greenhouse.
Will use one Arduino to run the irrigation system, one for temp, rain and light messurement. Finally one Arduino to run 4 relays for my outdoor light.

I got this in my mail today:

Hello, since there is APi we could support this. First we will check details and let you know when we release support.

Best regards

On Sat, Sep 17, 2016 at 8:05 PM, info@nhome.ba wrote:
From: <lars>
Subject: sensor network

Message Body:
Will you add support for MySensors?
You can find out about it at www.mysensors.org

--
This e-mail was sent from a contact form on nhome (http://localhost/wordpress)

NHome Team

A: Blajburških žrtava b.b.
88000 Mostar - BIH
M: +387 63 304 013
E: info@nhome.ba
W: www.nhome.ba

:)

Thank you!!!!!
That helped a lot.

:)