Hi,

Just wanted to give an early "heads up" of a gateway I'm creating in order to have the wonderful world of MySensors at home with a RabbitMQ server and openHAB as HA controller. I wrote the following blog post on http://blog.scurb.se/homeautomation/my-own-mysensors-gateway/.

I had no intention to write this post as a "advertisement post", I hope it was not taken as such. I'm about to clean up and prepare the project in order to publish on GitHub.

Best regards,
Patrik

@sundberg84

Been a while since I made sensors now - but so what.. ordered 10 pcs in order to try it out

@sundberg84

Been a while since I made sensors now - but so what.. ordered 10 pcs in order to try it out

Thanks for the positive response!

@Yveaux - RabbitMQ was my choice primarily because of:

• I have other applications using AMQP protocol and Rabbit supports multiple protocols (amqp, mqtt, xmpp etc)
• I previously worked with RabbitMQ so it was less "unkown" among the many brokers.
• I like the possibility of setting up central services as active/active and active/passive nodes. Even though I haven't the actual need for such a high availability solution at home

However, the application should be broker agnostic and support to connect over MQTT no matter which message broker used.

/Patrik

Hi,

Just wanted to give an early "heads up" of a gateway I'm creating in order to have the wonderful world of MySensors at home with a RabbitMQ server and openHAB as HA controller. I wrote the following blog post on http://blog.scurb.se/homeautomation/my-own-mysensors-gateway/.

I had no intention to write this post as a "advertisement post", I hope it was not taken as such. I'm about to clean up and prepare the project in order to publish on GitHub.

Best regards,
Patrik