@rejoe2
Thank you for helping me in the right direction
I do not think there is anything wrong with the hardware because I have two identical sets. One to a spa and a heat pump. Maybe I'll try it with less resistance. Now i have 4.8kohm

I'm now trying with more or less distinction from the former transient temp.
I will reply when I got it to work.

Tomas

@rejoe2

Now I have tried both of the programs. It works much the same. It pops up a fault sometimes.
Is it difficult to enter a line in the program, says that if the temperature has changed system than - + 5 degrees so it shall not be reported

@rejoe2

Thanks so much for your help.
I think you're a little ahead of me in programming. Interesting with time delay between temp sends. How do I create it?

@rejoe2
I will try to change.
Here is a picture where you see that the sensor ID picks temperature of another sensor

@rejoe2
Thanks
I have now tried the stored ID "version and it works much better than the previous.
I still get the wrong values sometimes. Wonder if there is control domoticz which mixes the ID.

How can I get this to work with 2.0 or 2.1.1
I would so much have to help because I am a beginner

Is there anyone who has received a onewire to work with 10 dallas temp.
it works for me but I would like that it was fixed ID (children) of the sensors

Re: About DS18B20 onewire.

Hello
I have 10 dallas temp sensor into to an Arduino. The problem is that sometimes domoticz mixes temp sensors together. Any more having the same problem? Or does anyone have a solution.
Tomas