Posts made by Tsjippy

thanks for the answer. The seller did only reply with the manual not with the protocol to bad

Hello all,

I bought this device and it uses a radio module to communicate with its display.

I can define my own address with a number from 0-125.

My question is how can I listen to the data it is broadcasting?

@mfalkvidd
I was to quick, it was working so I used it to solder a PCB. That did not work, so tested again on a breadboard. Now it did not work. So I tried:
4.7
22
33k
47
47+22

Both on the breadboard and directly connected, not with power from the batteries and from the arduino, but it not work. He never gets a reply back.

So it has worked, but know it doesn’t, when I connect a stable powersupply it works.

What else should I try?

Thanks, I missed that!
I did not have a capacitor connected. After connecting a 47 uF and a 22 uF cappacitor, it works.
Thanks

I have tried to make a batttery powered sensor by connecting 2 AA batteries to a step up convertor, which outputs 3.3V. I hooked that up to a arduino pro mini 3.3v and connected a radiomodule (MY_RADIO_RF24).

The sytems work just fine when connected to my a FTDI adapter which is connected to my laptop.
It does not work when powered from batteries. In fact it even works when I power the arduino from batteries and power the radio module from the FTDI.

When its not working, it does send messages, but never receives an answer back from the gateway.
Any clue how I can fix this?

Hi All,

I try to install MySensors on my rpi3B.

I have run these commands:

git clone https://github.com/mysensors/MySensors.git 
cd MySensors
./configure --my-transport=rf24 --my-gateway=serial --my-serial-is-pty --my-serial-port=/dev/ttyMySensorsGateway
make```

I get this error in "bin/mysgw":

Jun 01 20:10:37 INFO Config file /etc/mysensors.conf does not exist, creating new file.
Jun 01 20:10:37 ERROR Unable to create config file /etc/mysensors.conf.
Jun 01 20:10:37 ERROR Error opening config file "/etc/mysensors.conf".

Any idea? sudo make or sudo make install does not make any difference