Ok, running on 2.1.1 and commented out the following lines:
#define MY_GATEWAY_MAX_CLIENTS 20
is running now for three days and looks good that it will keep it that way.
ok, starts to crash again. I replaced the whole hardware aswell.
Yes if I uncomment them, the nodes connect normal.
I'm not using v.2.1.1, my nodes and gateways are on v.2.0.0
The next step will be to use an esp8266 as gateway instead of the arduino uno.
It stopped crashing.
But the problems just switched.
Only one device is communicating with the Gateway. The other devices aren't working anymore. My Relays and one temp and hum sensor are not communicating any more.
And they are 5 meters away from the Gw.
Thanx for your answer.
That means, if I would use an raspberrypi as a gateway that could support devices?
I would like to have only 1 gateway for each floor and I plan to have about 20 sensors connected to each gateway .
Looks like your connection to MySensors Forum was lost, please wait while we try to reconnect.