Repeaters in domoticz
-
-
Domoticz does not distinguish between messages directly from nodes or via repeaters. Sometimes I have it happening too that messages do get send but do not pass the repeater. It gets solved by erasing the Eeproms in repeater and node. But I realize it is not the best solution.
-
From the view of Domoticz it has no information how messages were routed on its way to the controller. So you should probably start to look at the debug prints of the gateway and work your way to the node to see where communication stops.
What type of sensor are you building? Is it supported by Domiticz?
-
Go this going by playing with the ordering. I wiped sensors from domoticz and turned on repeater node. Then I restarted domoticz - then opened my reed switch (outside electric gate) - this caused the gate to be registered. I then had to reset the repeater (it is a buzzer and led actuator) for that to be seen in domoitcz also. A bit convoluted but got there. Guess this could trip many up.
Thanks all.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login