Looped Repeater
-
Hello,
In my installation all nodes are repeaters.
When I switch off the gateway, the nodes search a new route and begins to loop.When I switch back the gateway ON. some nodes never find the correct route again.
I have then to power off all the nodes excepted the gateway and restart each node one by one.
Where is my mistake ?
Pierre
-
Please ... help me ...
-
It might take a while for all nodes to restore a working topology.
@celonunes might have found a bug that could explain part of this behaviour.
-
Hello,
I understand that the topology reconstruction may take some times ... But after more than 24 hours of waiting some nodes are not connected to the gateway.I only have 7 nodes in home and they are close to each other. They are all repeaters . It is may be too much repeaters ??
-
No point in having this many repeaters if they are close to each other.
Start by having none of them. And add one if needed.
-
I have the same situation. My solution is to add manually repeater id in each node.
-
This post is deleted!
-
Thank you .... Happy to know ... I am not alone with this problem.
Do you mean that each repeater have a fixed parent's node ID.
And when you give "0" as parent node... that's a first level repeater linked to the gateway ??
For the "non-reaepter" nodes did you fix the parent id too ?
-
Yes and yes. first lever repeater should have id 0. All my nodes have static repeater or gateway id. Now i don't have loops after restart gateway.
Suggested Topics
-
Day 1 - Status report
Announcements • 23 Mar 2014, 22:45 • hek 24 Mar 2014, 20:12 -
Raspberry Pi 5: invalid GPIO 9
Troubleshooting • 27 Aug 2024, 13:20 • igo 27 Aug 2024, 13:20 -
Some sensors permanently fail after one/two years
Troubleshooting • 25 Jul 2024, 17:17 • Kokosnoot 25 Jul 2024, 17:17 -
Arduino nano and Uno in same My sensors network with NRF24L01+
Troubleshooting • 26 Jul 2024, 10:30 • DIY89 27 Aug 2024, 09:59 -
Echo request is not set
Troubleshooting • 12 Aug 2024, 15:36 • kamilb85 3 Sept 2024, 08:58 -
Forum Search not working?
Troubleshooting • 4 Oct 2023, 23:33 • Gibber 2 Sept 2024, 20:28