Duplicate Sensors

[diggs]

Not sure if this is a Domoticz or MySensors question, but I seem to get a lot of duplicate sensors in Domoticz. Anyone seen this before and have an idea what it is about or how to stop it. ID's are the same

[AWI]

Domoticz is combining humidity and temperature sensors when both are in the same node. You can just delete the 'not updated' one. The combination rather arbitrary / confusing when you have multiple temperature humidity sensors in one node..

[diggs]

@AWI Thanks for the reply. When I first setup the sensors I am sure i deleted those extra ones, but they seem to have come back again for some reason. Is there a way to permanently delete them?

Will Domoticz always combine the temp and humidity if they are from the one DT22 sensor? Would be good to report and graph them separately

[fleinze]

I think you could prevent them from coming back when you disable "Accept new Hardware Devices" in the settings-section.
I habe a similar issue with a power-meter sensor. From time to time a new device appears which is never updated.

[diggs]

Ok, Thanks. Will give that a try