OTA updates on Arduino Nano

[rvweert]

Hi Tekka,

Please see here my log:
MySensors_20151109-085110.log

Also yes, all my nodes are running the same version from git.

Cheers,

Rene

[Oitzu]

@rvweert: i see no bootloader involved. Could you try to add an wdt_reset(); at the beginning of the setup() routine?

[rvweert]

Hi Oitzu,

Just tried that, same result...

[rvweert]

No more news on this?;-)

[Oitzu]

@rvweert out of ideas by simply looking at the logs.
Maybe @tekka knows anything.
Did you try to enable debug on the node and look at the nodes output?

[tekka]

@rvweert I'll look into that in a little bit.

[tekka]

@rvweert there is potentially an id conflict: was the node previously used as gateway? Anyhow, try clearing the eeprom with the ClearEepromConfig sketch and upload the log again.

[rvweert]

Hey Tekka,

Tried clearing both eeproms, still same problem. Actually tried two completely new nano's and same problem again...

[tekka]

@rvweert Looking at the logs, there is no bootloader involved (@Oitzu already confirmed this).
This looks like a bad nRF chip and/or power issues (try with different a cap) since the msgs sent from the GW never reach the node.

[tekka]

@rvweert MY_OTA_FIRMWARE_FEATURE enabled in MyConfig.h? This seems to be the cause of the restarting nodes. Try disabling this option unless you are using the sensebender board...

[rvweert]

@tekka I checked but MY_OTA_FIRMWARE_FEATURE wasn't enabled. Also I tried Mysensors 1.4.1 and 1.5.2 but same result. Can't get it to work;-(