@rvweert out of ideas by simply looking at the logs.
Maybe @tekka knows anything.
Did you try to enable debug on the node and look at the nodes output?
@rvweert out of ideas by simply looking at the logs.
Maybe @tekka knows anything.
Did you try to enable debug on the node and look at the nodes output?
@rvweert there is potentially an id conflict: was the node previously used as gateway? Anyhow, try clearing the eeprom with the ClearEepromConfig sketch and upload the log again.
@rvweert Looking at the logs, there is no bootloader involved (@Oitzu already confirmed this).
This looks like a bad nRF chip and/or power issues (try with different a cap) since the msgs sent from the GW never reach the node.
@rvweert MY_OTA_FIRMWARE_FEATURE enabled in MyConfig.h? This seems to be the cause of the restarting nodes. Try disabling this option unless you are using the sensebender board...
@tekka I checked but MY_OTA_FIRMWARE_FEATURE wasn't enabled. Also I tried Mysensors 1.4.1 and 1.5.2 but same result. Can't get it to work;-(
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
