Decimals not appear at Vera UI

[rabeliyo]

Hello , I am modifying files multimeter to work well in UI7 , so far work well , but can not get me decimals appear in the interface vera ( in arduino if displayed) , only the first number , for example appears .

Sketch

gw.send ( msgVoltBat.set ( ( int ) VoltLevelBat , 2) , 1) ;

sends 3.95 volts and appears vera UI 3.00

I tried to change the type of variavle in S_Multimeter1 to i4 , UI4 , string , float without results.

Use this skit to control the voltage of the battery and solar module and need to be accurate.

Thank you very much

[hek]

@rabeliyo said:
VoltLevelBat must be a float (or casted to a float) when calling set.

[rabeliyo]

ok!! Like this?

float VoltBatScale = analogRead(A2);
float VoltLevelBat = VoltBatScale*4.12/376; //376 is the analog read at 4.12v (full charged battery)
if (VoltLevelBat != lastVoltLevelBat) {
gw.send(msgVoltBat.set((float)VoltLevelBat,2),1);
lastVoltLevelBat = VoltLevelBat;

[BulldogLowell]

@rabeliyo

yes, but you shouldn't need to cast a float to a float like you are doing here:

gw.send(msgVoltBat.set((float)VoltLevelBat,2),1);

also, because of the way floating point numbers work:

if (VoltLevelBat != lastVoltLevelBat) {

may be a LOT more frequently than you may actually wish. Consider just updating the controller with a simple timer instead.

[rabeliyo]

Works!!! Thanks a lot, i upload my remake of multimeter for UI7, all works but i only use the current and the voltage for my solar module, i will change the impedance to Kw/h

Vera Files:
http://www51.zippyshare.com/v/fk2Ay5ww/file.html

Now i have a problem with the 3.3 PIR mod, i open a new post XD