Dust sensor GP2Y1010

[moskovskiy82]

Wondered if i should update a really old thread.
There is a dust sample example on the build page. The photo looks exactly like GP2Y1010.
But for wiring only 3 pins are supposed to be used which is completely different from the pin out. Is some middle board used in this example?
Than what should be the correct wiring for the raw sensor?

[hek]

Might be good to ping @epierre on this one.

[moskovskiy82]

Ping with no success yet

[alexsh1]

@moskovskiy82 said:

GP2Y1010

There are many sketches available for Arduino:

http://arduinodev.woofex.net/2012/12/01/standalone-sharp-dust-sensor/

You have to (1) adopt it for MySensors (2) change it according to your needs

Good luck