Dust sensor GP2Y1010
-
Wondered if i should update a really old thread.
There is a dust sample example on the build page. The photo looks exactly like GP2Y1010.
But for wiring only 3 pins are supposed to be used which is completely different from the pin out. Is some middle board used in this example?
Than what should be the correct wiring for the raw sensor? -
Ping with no success yet
-
@moskovskiy82 said:
GP2Y1010
There are many sketches available for Arduino:
http://arduinodev.woofex.net/2012/12/01/standalone-sharp-dust-sensor/
You have to (1) adopt it for MySensors (2) change it according to your needs
Good luck
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login