Error while compiling the Ethernet Gateway

[alexsh1]

Hello,

I tried to change a few options and now I cannot compile the gateway with "#define WITH_LEDS_BLINKING" in MyConfig.h:

del:109: error: no matching function for call to 'MySensor::MySensor(MyTransportNRF24&, MyHwATMega328&, int, int, int)'

 MySensor gw(transport, hw /*, signer*/, RADIO_RX_LED_PIN, RADIO_TX_LED_PIN, RADIO_ERROR_LED_PIN);

If I disable it, it complies fine. Any idea what the problem may be? I am using Arduino 1.6.7 on Windows

[ausbremen]

Hello,

I have almost the same error when compiling ValloxSensor:

ValloxSensor:351: error: no matching function for call to 'MySensor::MySensor(int, int)'

MySensor gw(CE_PIN, CS_PIN);

                       ^

Propably the library has changed?

[alexsh1]

This only happens when #define WITH_LEDS_BLINKING" in MyConfig.h is set.
Maybe @hek can help?

[hek]

I doubt we'll do any patches in 1.5 now.

I suggest you make the jump to the development branch. It's soon ready for release.

[ausbremen]

@alexsh1
in MyConfig.h #define WITH_LEDS_BLINKING" is commented out

/**********************************

• Information LEDs blinking
  ***********************************/
  // This feature enables LEDs blinking on message receive, transmit
  // or if some error occured. This was commonly used only in gateways,
  // but now can be used in any sensor node. Also the LEDs can now be
  // disabled in the gateway.

// #define WITH_LEDS_BLINKING

// The following setting allows you to inverse the blinking feature WITH_LEDS_BLINKING
// When WITH_LEDS_BLINKING_INVERSE is enabled LEDSs are normally turned on and switches
// off when blinking

//#define WITH_LEDS_BLINKING_INVERSE

[alexsh1]

In this case I do not understand.

Perhaps, @hek is right. I have updated a few nodes to v2, but the GW was still v1.5.2
The problem is that I do want signing and with all debug options, I just cannot get 36Kb compiled on my Arduino Uno (GW).