Looking for tips on mounting thermal fuses.
-
I just ordered 20 more for my parts bin. You can kind of see in this picture, I soldered the one in and blew it, so I just cut the leads leaving them stubbed off so I could solder the new one to those leads rather than try to remove and re-mount it to the board.
-
I just ordered 20 more for my parts bin. You can kind of see in this picture, I soldered the one in and blew it, so I just cut the leads leaving them stubbed off so I could solder the new one to those leads rather than try to remove and re-mount it to the board.
-
Gripping it with nose pliers between the fuse itself and where you are soldering should absorb a lot of the heat, especially id you make sure the pliers are cold when you start soldering. Nose pliers can absorb much more heat than alligator clips.
But I like Yveaux's idea to not solder at all. How about soldering female header pins and just stick the thermal fuse in?
-
Gripping it with nose pliers between the fuse itself and where you are soldering should absorb a lot of the heat, especially id you make sure the pliers are cold when you start soldering. Nose pliers can absorb much more heat than alligator clips.
But I like Yveaux's idea to not solder at all. How about soldering female header pins and just stick the thermal fuse in?
@mfalkvidd I am just guessing here because I have not actually tried it, but I am guessing that the holes would be too small on the female header. In order to get it to fit in the proto-board that I use, I have to drill the hole slightly larger which is why I think that, but it never hurts to try. Making the holes larger on the PCB is one of the main reasons why when these have blown on me I have cut the leads and left them in the board. I was afraid that the pads on the board would lift if I did because making the holes larger I am sure took away the thru-hole plating.
-
@dpressle said in Looking for tips on mounting thermal fuses.:
I just wrap it with wet toilet paper, works every time.
Haha that's a funny way to do it, but the concept is good thank you for the idea
I didn't have problem before but as a precaution I'll use with a small sponge for soldering iron, it will hold more water, be less messy and resist to heat. -
@dpressle said in Looking for tips on mounting thermal fuses.:
I just wrap it with wet toilet paper, works every time.
Haha that's a funny way to do it, but the concept is good thank you for the idea
I didn't have problem before but as a precaution I'll use with a small sponge for soldering iron, it will hold more water, be less messy and resist to heat. -
Am i the only one that struggles my as off with 4 pairs of pliers on these little annoying things?
-
My only precaution is to raise(!) the soldering iron temperature. It allows a fast action with less propagating heat. It sounds foolish, but I actually like it and rarely fail.
-
My only precaution is to raise(!) the soldering iron temperature. It allows a fast action with less propagating heat. It sounds foolish, but I actually like it and rarely fail.
-
My only precaution is to raise(!) the soldering iron temperature. It allows a fast action with less propagating heat. It sounds foolish, but I actually like it and rarely fail.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login