Motion, Temperature and Relay in 1 node
-
Hi,
I've been thinking about building motion, temperature and relay in 1 node, but would that be possible with a mini pro or a nano?
-
@Hausner said:
Hi,
I've been thinking about building motion, temperature and relay in 1 node, but would that be possible with a mini pro or a nano?
It's possible to do it, however you probably need to use as wallplug for power.
/ Thomas
-
Yes, I was aware of the necessary wallplug, but that is OK as I would need to run the mains power to the relay anyway.
Well, I better start coding then
-
I have a node with the same sensors. Currently on a nano, moving to pro when I get step-down's in. Works just fine. It will be auto controlling a second intake fan to my electronics closet at X temperature. For now, I just have it always on, but controllable via Vera, and logging the temp. Motion is there, I want it to trip a second relay for a light, at some point.
-
Cool
This is my initial sketch, but i'm still tuning it.
http://forum.mysensors.org/topic/597/motion-relay-sensor-sketch-helpI need to figure out only to send GW messages on an update.
