@mjdula The 85 reading is actually an error message used by the ds18b20 to indicate it has not had time to complete the processing of the reading. Most commonly this is only seen when the node first boots up and can be ignored or fixed by adding a small delay. You will find a lot of information on this if you do a google search. I have never experienced it myself but from other posts on the net it seems power supply problems and long cable runs to the sensor can also cause the error. Some have also had success by using a different resistor value. Note you only need one resistor fitted near your nodemcu not a resistor at each ds18b20. If the 85 reading is well outside your expected reading you could just filter out any readings over 84 as well.

@mfalkvidd Thanks for your help. MYScontroller seems to be able to replace the gateway assignement. I was running it for troubleshooting and it assign ID that gateway already used. So I created dummy ID in MYSController to ensure that node does not use the first one