Thanks for all the info all
But still have the problem with vera3 on ui7
Cribben, I follow the instructions on the my sensor vera plugin and it comes up with ver 1.3 and no lib #
how did you get the new plugin to load
Any help at all would be welcome as ui7 is not too smooth yet.
when you change the BAUD rate setting in the source/config file to something lower/other you can also use 3.3V Arduinos as (Serial)Gateway. Of cause your controller needs also to be told about the lower BAUD rate.
Check out http://wormfood.net/avrbaudcalc.php?postbitrate=9600&postclock=8 for an overview of Clockspeeds (usually 8MHz for 3.3V and 16MHz for 5V types) and coresponding BAUD rates.
Im using the serial gateway on u17 and have it working fine. i have the same problem as you when my vera is rebooted or powered off, but found 2 solutions. 1 with the vera on disconnect then reconnect the serial gateway. wait 10seconds refresh the dashboard page. Then go to app/ developer apps/ serial connection. Reset your baud rate to 115200??...
Thansk. I ended up upgrading to the latst UI7 beta. My gateway is now working!!! Let's see how stable it is.
(UI7 has fixed some of my other issue too)