Ethernet Gateway on Arduino nano

[meddie]

Hi,

i am new to mysensors, and i have an another Problem, but i have an Arduino Nano and when i compile the Sketch it shows that this use 95%. So it dows work for me.
I hope its usefull for you.
Maybe you have some libriaries which will be comiled in to arduino. Try to load only MySensors libs in Arduino Programm.
Greets Eddie

[Yveaux]

@MrTomtom said:

ENC28J60

Code footprint for ENC28J60 is significantly larger than for W5100.
Any chance you can use a W5100 for the gateway?

[MrTomtom]

@meddie: did you use also an ENC28J60 for lan-connection? or an W5100?

@Yveaux: yes, the chance is real. I can order a lan-shield with W5100. But i could not believer that it's not possible to compile the gateway with an ENC28J60... And the ENC28J60 looks nicer with the arduino, so i get a small package with lan-shield, arduino and rf-shield. :)

Anyone had compile successfull the lan-gateway wtih ENC28J60?
Greets
Thomas

[meddie]

Hi yes i have an enc and I can compile. 95% used.

[MrTomtom]

Strange.... on which platform do you compile? Windows, Linux? and which version do you use of arduino ide?

[meddie]

Hi,
on Windows 7 arduino IDE 1.6.6.
I have to use win 7 because i use a Clone of arduino nano and this have a prolific 2303 Chip wich Has only drivers for win 7.

[Yveaux]

@MrTomtom @meddie Which MySensors library are you using?

[meddie]

the newest 1.5.1

[BSB]

Remark out as many serial statements as you can.
With any luck you can scrape a few bytes back and it will compile and run.

Even if you have some form of debug define set for serial output the serial statements are still viable memory hogs.

[mfalkvidd]

MySensors 1.6 (still in development) is quite a lot smaller than 1.5. You cound try it and see if it is enough.