Signing ATSHA Key?

[alexsh1]

After you generated the keys and did your first node, do the following for soft signing:

Enable USE_SOFT_SIGNING
Enable LOCK_CONFIGURATION
Enable STORE_SOFT_KEY - must be the same
Enable STORE_SOFT_SERIAL - must be individual for each node/GW
Enable STORE_AES_KEY - must be the same

Below the options above you have to insert your keys.

EDIT: just corrected what you should enable

[alexsh1]

@Takero said:

Thanks! Now i am on the right way :-D

Finaly i'f got a HMAC_KEY.

On my Soft_Signing GW i have to enable USE_SOFT_SIGNING and STORE_SOFT_KEY (with the HMAC_KEY) and run the SercurePersonalizer.ino on my GW? Right?

Yes

[alexsh1]

ATSHA204A and soft signing are very similar in the sketch. You have to enable/disable corresponding options

[Takero]

@alexsh1 Thanks! I will try it later if my doughter is sleeping.

[Takero]

Works :+1:

[DavidZH]

I'd like to ask a follow up question to this old topic:

I have been able to create a set of keys using my GW on a Moteino (16MHz).

Now I'd like to program the keys into a some nodes. A few of these are running a bare 328p at 1MHz as a battery sensor, but a baudrate of 115k is a bit high. I only get garbage in the serial window, so no checking if the keys are stored properly.
Wouldn't it be wise to lower the baudrate of that sketch to be able to accomodate slow battery sensors. I have looked to try to do it myself, but was unable to find where.

[mfalkvidd]

@DavidZH I think you can add

#define MY_BAUD_RATE 9600

before including MySensors.h to set baud rate to 9600bps (change to even lower if you need to)

[DavidZH]

I had already tried that (I just did again, to be absolutely certain) but even at 4800 I still get garbage. I know 9600 baud works because of a test I had running before I tried the personalization sketch. I added the
#define MY_BAUD_RATE 4800 before the inclusion of the MySensors.h file.

[mfalkvidd]

@DavidZH 115200 seems to be hardcoded in the sketch. Try changing it. Search for 115200 https://github.com/mysensors/MySensors/blob/8e1ef13804f2737079298c63bd0d8aa7b82e7f73/examples/SecurityPersonalizer/SecurityPersonalizer.ino#L717

[DavidZH]

Thanks a bunch! That did it! I always forget to use the "find" when I'm doing things like this. And the serial.begin was in line 881, I didn't expect it to be that far down.

[mfalkvidd]

@DavidZH great, thanks for verifying! I have created an issue on github https://github.com/mysensors/MySensors/issues/758