Humidity/Temp Program, Serial Monitor Issues
-
Hello,
Created a device using the humidity sensor code (http://mysensors.org/build/humidity).
All appears to be working fine(aside from some wacky temps off by about 10 degrees F), except when I go in to serial monitor to see the units output, all I get is the below gibberish.
ý
ËP+21úÙUÙS,;jôØ"éUÙS)$º«)µÎq¤ÛI¶RSs%[º»q1©qÂüÙ÷eÎ|ÌÅÉûI.þÀ!S)Z<ÖT}rùÿº»@ÙSrz ü5}ráÿPµâÂêÙ$þp ü¦¬µq\ÿº»Dy ÍSsµÿ«üeÎ| ºüAny ideas?
-
make sure to select he proper baud rate in the serial monitor.
-
@hari DOH, that was it. Thanks!
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login