@ BartE , thanks a lot , I changed all the _Off to _OFF and the same with the On , gw. wait as well. also the 500 to 5000
Working perfectly !
Many thanks
I haven't had a definite anwer yet if libabry 2.x works on vera , I have only read about problems . For the moment I stick to 1.5
edit : one small thing I just noticed , when I switch via the vera Gui the relais to off , it nicely goes back to on after 5 seconds , but it doesn't report back to vera that it is again in an on state.
is there still something wrong with the code?
Again many thanks,
Cor
For future reference:
// Example sketch showing how to control physical relays.
// This example will remember relay state even after power failure.
#include <MySensor.h>
#include <SPI.h>
#define RELAY_1 3 // Arduino Digital I/O pin number for first relay (second on pin+1 etc)
#define NUMBER_OF_RELAYS 1 // Total number of attached relays
#define RELAY_ON 1 // GPIO value to write to turn on attached relay
#define RELAY_OFF 0 // GPIO value to write to turn off attached relay
MySensor gw;
void setup()
{
// Initialize library and add callback for incoming messages
gw.begin(incomingMessage, AUTO, true);
// Send the sketch version information to the gateway and Controller
gw.sendSketchInfo("Relay", "1.0");
// Fetch relay status
for (int sensor=1, pin=RELAY_1; sensor<=NUMBER_OF_RELAYS;sensor++, pin++) {
// Register all sensors to gw (they will be created as child devices)
gw.present(sensor, S_LIGHT);
// Then set relay pins in output mode
pinMode(pin, OUTPUT);
// Set relay to last known state (using eeprom storage)
if (gw.loadState(sensor) == RELAY_OFF) {
digitalWrite(pin, RELAY_OFF);
gw.wait(5000);
digitalWrite(pin, RELAY_ON);
}
}
}
void loop()
{
// Alway process incoming messages whenever possible
gw.process();
}
void incomingMessage(const MyMessage &message) {
// We only expect one type of message from controller. But we better check anyway.
if (message.type==V_LIGHT) {
// Change relay state
if (message.getBool() == RELAY_OFF) {
digitalWrite(message.sensor-1+RELAY_1, RELAY_OFF);
gw.wait(5000);
digitalWrite(message.sensor-1+RELAY_1, RELAY_ON);
}
// Store state in eeprom
gw.saveState(message.sensor, message.getBool());
// Write some debug info
Serial.print("Incoming change for sensor:");
Serial.print(message.sensor);
Serial.print(", New status: ");
Serial.println(message.getBool());
}
}```
