@donny152 You should try OpenLuup. works great with mysensors and vera plugings and is very stable and you can use your vera as a zwave controler. http://forum.micasaverde.com/index.php/board,79.0.html

[image: 1462873937252-water-pressuresensor.png] Update: I figured out how to make a few changes to the Vera device display. Now for some reason all three are reading from one analog pin. I have each one of them set on A0, A1, A2. Never mind as I was writing this post I think I figured out what I done wrong. For some reason I had the A0 pin defined twice in my sketch. Still need to test it an see that's the problem. And the only thing I have left to try an figure out is in the Vera Scenes the language is still in French. Anybody have any ideas how I can fix this??

@sundberg84 Got it all to work after using a new Atmel328 chip on a extra Arduino Uno board I had. I'm guessing the clone board, from china, I was trying to use has some kind of issue with eeprom or some other issue. Couldn't get it to responded to on or off signal or couldn't get the radio strength issue worked out either. Again Thank you so much for your help!