First of all. thank you guys for all the help! here is what i found out. When testing my hardware i found that alone with the MySensors Dallas sensors sketch i would get readings from my Dallas sensors in serial and at controller. With relay sketch alone i would get All 4 relays working in controller and in serial. But combined no Dallas temp in serial or controller. I rewired with new sensors, Arduino nano, radio! Finally digging through my stuff i found a new board from a batch ordered 2 years ago, wired it up on bread board and wallah! Apparently the last batch or boards i ordered must have not passed quality or damaged in shipping!! Thanks again for the support!! On a way brighter note I have address's assigned to my temp sensors now on all my nodes and have learned so much more about the MySensors network!

I just started using nodemanager. GREAT WORK! Might be a dumb question but how do i add more than one relay to the sketch? I would like to control 4 but only can get one to work. Thanks in advance!

This is what i use to configure my raspberry pi3 to work vi serial.

--my-transport=rf24 --my-rf24-pa-level=RF24_PA_LOW --my-rf24-irq-pin=15 --my-gateway=serial --my-serial-is-pty --my-serial-pty=/dev/ttyUSB020 --my-leds-err-pin=12 --my-leds-rx-pin=16 --my-leds-tx-pin=18

Built using this page. https://www.mysensors.org/build/raspberry

And when recieving this error "Dec 31 11:07:50 DEBUG !TSM:INIT:TSP FAIL" I had found a bad jumper that I had used. Hope This helps!

In your configuration try leaving the "--my-controller-ip-address=127.0.0.1" out of configuration. Another thing to try is to power the radio connected to the pi by a separate 3.3v power supply. also when i built my first controller/gateway i spent 2 days trying to figure out why it didn't work when in the end it was a bad jumper wire. Unhook everything and double check your wiring. Hope something helps! :)