First of all. thank you guys for all the help! here is what i found out. When testing my hardware i found that alone with the MySensors Dallas sensors sketch i would get readings from my Dallas sensors in serial and at controller. With relay sketch alone i would get All 4 relays working in controller and in serial. But combined no Dallas temp in serial or controller. I rewired with new sensors, Arduino nano, radio! Finally digging through my stuff i found a new board from a batch ordered 2 years ago, wired it up on bread board and wallah! Apparently the last batch or boards i ordered must have not passed quality or damaged in shipping!! Thanks again for the support!! On a way brighter note I have address's assigned to my temp sensors now on all my nodes and have learned so much more about the MySensors network!
