Im on UI7 and have the same issue, on the github development all files are many many months old, the should be newer than like 8 months???

Regards,
Jan

@Dwalt

Hi,

Im also looking for documentation on this

Regards,
Jan

@mfalkvidd

Hi,

I have look at both of them... But my interest lies in the esp8266 as a client/node without NRF24L01, to eg switch a relay on/off... And it has to go through my Vera controller... I have been playing with Apples Homekit, Raspberry Pi and Vera, and now i can control my vera switches and dimmers with just my voice

Regards,
Jan

@hek

Hi, In the 3 post is there a link https://github.com/mysensors/Arduino/blob/development/libraries/MySensors/examples/GatewayESP8266/GatewayESP8266.ino#L104... The link is dead and i tried to find it, but with no luck... Can you post the new URL?

Regards,
Jan

Hi,

I did'nt have much succes with the radiodevice, and i have made the gateway

But have i missed the code eg for the sensors???

Regards,
Jan

Hi,

That im will try to work with I have seen the one in your post, and i hope the one from dx is the same, but i'll keep you posted

Hi,

I found module from DX that i want to try, i dont want to mess with 220v cables So i waiting for this one to come
http://www.dx.com/p/yqj010504-single-phase-ac-current-sensor-module-w-active-output-deep-blue-5a-294209#.VDOyK2d_t8E

They also have this item, but then you have to play with high voltage...
http://www.dx.com/p/single-phase-ac-voltage-sensor-module-deep-blue-346690#.VDPO5md_t8E

Regards,
Jan

Hi,

I have a lot of arduinos lying around and thinking on turning them into a poweroutlet ac wattmeter... I have googled a lot and there are several solutions... But have any of you made a "poweroutlet ac wattmeter" connected to a GW?

Regards
Jan

Hi,

I triede it with version 1.2 and it worked fine, but a had to use the serial port in the vera for a RF device i changede it to ethernet version. Now i dont use the RF device anymore, in the meantime i was on version 1.3... So i decieded to upgrade to 1.4 and use the serial GW... None of my many Uno's Nano's and even a MEGA worked, the Vera couldnt see any USB, so i triede also with a powered HUB, different types of USB cables, still nothing... The i went back to the 1.3 version still nothing... Then i made a complete reset of the vera nad connected the Serial GW again, nothing...

Hmm, thinking if i should try the old 1.2 again or just keep the ethernet GW shield...

Regards
Jan

@BulldogLowell

Okay, now i better understand, because in the schematics the J1 is connected to pin 3 and i didnt get it to work, but also the D1 you use is Blue, but in the sketch the first one you use is white So now i got the 6 diodes connected, what about the other 6? are the connected parallel? (whites, red greens etc)

Regards Jan