I've downloaded the mysensors software, but what, where and how do i install the bootloaders from mysensors in order to get them to show up in arduino sketch?
And after that how do i install them on my arduino??
@jaydenlord Probably you do. If you leave the EN floating, electrical noise could cause it to enable or disable randomly.
Some enable pin require a HIGH, some LOW. Connect it to VCC to see if it works more consistently. If it doesn't detect, connect it to GND.
If one of these works, then the part wasn't designed to be in a default state of enable.
Let us know your results (I found this video
OSD
@tnick STM32F1 2019.12.8 (stm32duino) is the version that was active when the latest MySensors release was made. Later versions may or may not work; nobody would know until they tried.
Update and problem fixed!
For everybody that will encouter this, the problem was at the sensor side because of the folder of the sensor! We created some metal brackets for it and they where exactly the same diameter. The fact that the mount squeezed the sensor made it return the lowest value.
Just needed to adjust the hole and everything was ok!