Reporting Battery Level

[Fat Fly]

I bought 2AA batteries. Working.Domoticz devices page report battery level 3. How to see battery level graph ?

[AWI]

@Fat-Fly to report battery voltage you have to create a S_MULTIMETER sensor and send the voltage with V_VOLTAGE.

Sendbatterylevel only changes the battery level in Domoticz in % and can not be shown separate.

Tot use your arduino with low voltages you need to change the fuse settings (BOD) with an ISP programmer.

[Fat Fly]

How to i do this ?

[AWI]

@Fat-Fly I will post some code later when I get to a pc. :eyes:

[Fat Fly]

@AWI said:

@Fat-Fly I will post some code later when I get to a pc. :eyes:

This is great. I do not find from google search. My mother tongue is Estonian :)

[AWI]

@Fat-Fly "Estonia: Between East, West and the World" ;-)

These are the lines of code which should do the trick... you need to put them in the right spot yourself

#define VOLTAGE_CHILD_ID 		5

MyMessage voltageMsg(VOLTAGE_CHILD_ID, V_VOLTAGE);	// Node voltage

gw.present(VOLTAGE_CHILD_ID, S_MULTIMETER, "Battery " );
	
float voltage = vcc.Read_Volts() ;
gw.send(voltageMsg.set(voltage,2));				//send battery in Volt 
		

[Fat Fly]

Estonia between world and russia. :)

[alexsh1]

@Fat-Fly I am not sure how you intend to arrange your electricity pulse meter reading, but in my case I had to wire Pro Mini 5V to mains or otherwise recharge a battery every 5-7 days. I think you can do the total kWh and putting Pro Mini to sleep, but you cannot have total consumption kWh and current consumption kW with sleeping.

[Fat Fly]

Yesterday this not working. KW reader is too away from gateway.My house is lenght is 22m. Electricity meter is one end of house and gateway is center house. can i use repeater on something other. I use for this nrf with antenna.

[mfalkvidd]

@Fat-Fly check the "range issues" troubleshooting flowchart at https://forum.mysensors.org/topic/666/debug-faq-and-how-ask-for-help