Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

ESP8266 ... doesn't connect to sensors

Meister_Petz last edited by
Hi,

my WLAN Gateway (ESP8266) doesn't connect to sensors or the other way round.

On the sensor side:
In serial monitor my test sensor asks for an ID but there is no reply

On the WLAN Gateway side:
In serial monitor:
- I can see the sensors broadcasts
- I can see, that the gateway switches to inclusion mode, by the inc button
- but no transfer to the sensors is sent out
Any ideas?

Many Thanks

Petz
Reply Quote 0
1 Reply Last reply
sundberg84 Hardware Contributor last edited by @Meister_Petz

@Meister_Petz - do you have any controller? The gateway does not hand out ID.
Reply Quote 0
1 Reply Last reply
Meister_Petz last edited by

Good point! I use FHEM... the Gateway is connected... so FHEM maybe the Problem...
Reply Quote 0
1 Reply Last reply

3
Posts

813
Views

Log in to reply

Suggested Topics

Day 1 - Status report
Announcements • • hek

3

0
Votes

3
Posts

1514
Views

Feels much faster from here too!
Extraneous info in Debug log
Troubleshooting • debug log • • Gibber

1

0
Votes

1
Posts

9
Views

No one has replied
Can not compile MySensors on esp8266
Troubleshooting • • TheoL

6

0
Votes

6
Posts

18
Views

@TheoL there are two pull requests adding support for newer versions. One is guaranteed to break again. One should not break in the future, but will instead break all existing sketches. I’m sure a third option would be welcome if you write the code and submit.
Raspberry Pi 5: invalid GPIO 9
Troubleshooting • • igo

1

0
Votes

1
Posts

7
Views

No one has replied
Arduino nano and Uno in same My sensors network with NRF24L01+
Troubleshooting • • DIY89

6

0
Votes

6
Posts

35
Views

I have mixed Nanos, Pro Minis, ESP8266 and Unos and no problem. I do however have mixed NRF24L01 and NRF24L01+ due to a bad AliExpress saler that stated he sold NRF24L01+ which in fact were not the + version. So I have set my baudrate on all nodes to 1mb. In order to be helpful we need the log on the Uno.
Echo request is not set
Troubleshooting • • kamilb85

2

0
Votes

2
Posts

17
Views

I've found that: char *protocolMyMessage2Serial(const MyMessage &message) { (void)snprintf_P(_fmtBuffer, (uint8_t)MY_GATEWAY_MAX_SEND_LENGTH, PSTR("%" PRIu8 ";%" PRIu8 ";%" PRIu8 ";%" PRIu8 ";%" PRIu8 ";%s\n"), message.getSender(), message.getSensor(), message.getCommand(), message.isEcho(), message.getType(), message.getString(_convBuffer)); return _fmtBuffer; } We put in the print "message.getEcho()", but this isn't echoed message. I think we should put "message.getRequestEcho()" here.

61
Online

11.4k
Users

11.1k
Topics

112.6k
Posts

Copyright 2019 Sensnology | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1