Reporting back: I have my BambuLab X1C printer setup and have printed with it for about a week. It's fantastic: it's fast, and the prints come out perfectly every time. Truly an appliance: it works with only minor setup straight out of the box. I'd say it's a quantum leap better than my Prusa MK3S, which I guess I should try to sell while it still has value.
To fix, first clean the nozzle to look like new from the outside. Next heat up the nozzle to temp and apply pressure to the filament with your fingers, usually this will push through a clog. If you cannot manually push filament through, consider replacing the nozzle or entire hotend.
Hi @laurabarreda
I'm a newbie here too. Found this forum to find 3D printer parts but haven't found an answer to my question yet.
When I was looking for a printer for myself, I was asked almost the same questions. When choosing, there were 2 important parameters - the possible transportation and printing of large products. I found Dremel Digilab 3D20 for myself, and when I bought it, it cost a little over $ 500. I am sure that if you look for it, you can find it for 500. Well, or buy from someone else (I mean previously used).
@evb my bad. The nodebb admin interface has a "Save" button that I didn't see so the changes I made were thrown away. I've re-entered the settings ans this time I clicked Save
@NeverDie Yeah, but when I priced out domestic places, they all wanted enough that the client just decided to go a different way. This was only going to be for a prototype, but even so, I got prices ranging from I think $10-50 per pin holder, and it was less than 2 grams of plastic each. I just checked again, and JLCPCB would do them for $1 each, and then $20 for quick shipping, and as low as $4 for the slow boat that takes a month. None of those options were very appealing at the time.
Digikey wants $13.66 each for this when I pick qty 10, so still not worth it for this project. Shipping with them is free, but I have no idea how quick they would be.
I also checked PCBWay, just for fun, and they quoted 1.24 at qty 10, for $12.45 total. Interestingly, the quote for 1 was $12.45 also. They wouldn't show an estimate for shipping without clicking the 'Submit' button and having a human engineer review the file for printability. Since I'm not actually going to do this now, I don't want to waste their time, so I don't have a total price from them for comparison.
As far as OP, this is a very old thread from 3.5 years ago, so I doubt that they still need help.
Very nice!
I knew it would only be a matter of time until we saw MySensors custom injected molded components!
I think if you made a box that could fit the Easy / Newbie board (~50x50cm) plus radio and 2AA batteries, you would probably sell a lot of them! I know I would buy some of those...
