Hello,
I have a few offical Nordic Dev Kits available if anyone would like them. 2 nRF24L01P kits with RF modules and main boards and a few nRF51-DKs. I am in the Pasadena, CA area near JPL. If anyone would like to meet to do a hand off let me know.
I would really like to get OTA working here as it's freezing outside and I have to go there to update the software in the greenhouse control system.
So please, can we have a 'how to' step-by-step guide to OTA? Please?
S.
Nice. I know there are RFM69's, but I've seen quite a few requests for the CC1101. Always good to have options.
I did something similar with the WIO-E5 chips in my repo. The E5 is not quite ready for prime time, but the basics are working.
I have many MySensors nodes, and still adding more. Good to see some new code for it.
@wrendral said in "Remote Irrigation with LoRaWAN: LM27313 Challenges and PCB Design":
I will go with a Li-Po Battery type: 304048 3.7V 1200mAh
Might work, but maybe the internal protection will trigger with the high current peaks. I'd suggest you plan a 0 Ohm, (2512/THT) resistor as R2 and then replace it with a 100Ohm/1Watt if the protection triggers.
@OldSurferDude Thanks!
I didn't touch the Arduino IDE for a while and forgot that the MYSBootloader doesn't come included in the Mysensor's library... My bad.
Thanks for the link! I should had searched first...
I use the OTA feature since 2017... It works well. So well that I forgot how to load the bootloader...
Regards!
