Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Mysensors et dual Bus

JeeLet last edited by JeeLet

Hello

a request for the possibility of a double bus .
a wired connection (rs485) and a wireless connection.

is this possible with Mysensors ??

Thank you
Reply Quote 0
1 Reply Last reply
mfalkvidd Mod last edited by @JeeLet

@JeeLet yes. Either use two gateways, or use https://forum.mysensors.org/post/105364
Reply Quote 0
1 Reply Last reply
JeeLet last edited by

view
Thank you for the link
I'll head in that direction
feedback after testing
Reply Quote 1
1 Reply Last reply

3
Posts

101
Views

Log in to reply

Suggested Topics

Vera Inclusion Not Working
Troubleshooting • • MisterE

19

0
Votes

19
Posts

9929
Views

@MisterE Good! If you try the "broken" radio with a capacitor it will probably work fine.
Presentation of a repeater / a node
Jeedom • • Banenabos

4

0
Votes

4
Posts

1616
Views

@Banenabos - if you have a situation where the GW is just within reach, if the node during some circumstances does not reach the GW it will after 6 (?) tries start to search for a new way. In this way it might be the node hops back and forth between the GW and Repeater->GW. I dont know whats the best practice is but when I had these situations i forced the ID to the repeater which was closest and most solid connection. Not very knowing in the code but above is based on observation and what works best for me. For example my rain/bucket sensor which is located in the garden can sometimes reach the GW directly but I lost connection to it back and forth. I added a repeater but for some reason it preferred the GW directly (less hops?) and lost connection over and over so I force it to use the repeater.
MySensors node doesn’t appear in Jeedom
Jeedom • • philoudumdum

6

1
Votes

6
Posts

3321
Views

Hello, Hallelujah, I managed to get everything working perfect. Shame on me The main problem came from a bad definition of the internal address (Network configuration section), in particular the "complementary" part of the address (/jeedom) which was not to be defined for me (check your URL Jeedom access to be sure). So I have : http://jeedom:80 where "jeedom" is 127.0.1.1 (as to be defined in /etc/hosts). Hope this help. Eric.
Cannot show history and graph
Jeedom • • jeppefugl

1

0
Votes

1
Posts

1191
Views

No one has replied
Jeedom controller and MQTT Gateway
Jeedom • • maler

2

0
Votes

2
Posts

25
Views

Hi, For MQTT in Jeedom you must use another plugin, you have mainly two choices : MQTT plugin by lunarok or jMQTT by domotruc. Check the market for those.
Jeedom controller and gateway on the same Raspi
Jeedom • • stef

3

0
Votes

3
Posts

1693
Views

Thanks but when you've added the MySensors plugin, how to configure the gateway in the MySensors configuration page of Jeedom ?

50
Online

11.4k
Users

11.1k
Topics

112.7k
Posts

Copyright 2019 Sensnology | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1