I NEED TO CHANGE ATTRIBUTE, V_VAR1 ON MY NODE (MYSENSORS) SERIAL. HOW CAN DO THAT WITH NODE-RED IN HA. I JUST WANT TO CHANGE VALUE BECAUSE I DON'T SEE ANY SERVICE CAN DO THAT.
Figured it out. I had to send HVAC_FLOW_STATE to HA, in order for it to figure out that it was a "thermostat". Only problem is that it shows up with states "Auto" "Cool" "Heat" and "Off" in the dashboard, even though I only have the possibility to heat, or turn it off.
@badisensors I have this same issue and am struggling to find a consice answer to the question. Have you figured it out?
I would love to see a bit more detail about the important naming and numbering protocals for Gateways, Nodes, Sensors, and their output values within the MySensors architecture. So far, I am not finding much and progress is slow when I simply need to try different iterations and make conclusions/adjustments.
@mfalkvidd I got what you mean.
Yes, I am using the tcp connection using the mySensors serial API, not the USB<>UART serial interface
I am running a gateway with the nRF24 at 1Mpbs for the fast & furious sensors (mainly energy meters); another at 250kbps for the battery supplied nodes (temp/hum and door sensors); another one at 1Mbps dedicated to the actuators / mission critical.
60 nodes running
Another on is a BLE<>Mysensors bridge between the Mopeka Tank Pro (2) and the TPMS (4)
Another one is a fauxmo<>Mysensors bridge.
A few esp32 based displays (round oled, 3.5", 7")
Hi,
Thank for your reply. Yes, i run since many years with a serial Gateway connected with my PI.
I thought it was possible to use the same machine to remove this extra element.
If you had a stability issue, I would just stick with my current formula and not change everything for now.
Regards,
