Mysensors Plugin - Lua Startup Failed

[hek]

Yes, it should be described here:
http://www.mysensors.org/controller/vera#including-new-sensors

[Sven Wolf]

Oh, maybe I should've scrolled XD

Thanks a lot guys. This will probably fix it.
//Sven

[heeythere47]

Hi, I have the same problem but when I go to serial port configaration all I get up is

"Serial Port configuration
If you connected the USB/serial device and it's not displayed here, reload Luup.Reload Luup
Not available"

Any help appreciated. Using vera lite u17. Thanks

[blacey]

@heeythere47

[heeythere47]

Tried this, hasn't helped. Same message as before. This from device page.
Would chinese clones be causing this problem?
Thanks Jamie

[Dwalt]

@heeythere47 Did you try what @5546dug suggested above? Your Vera is wanting you to "choose serial port". Check the baud rate and make sure the 'MySensors plugin' is selected.

[heeythere47]

Hi,
I have gone to apps-dev apps-config port. but it is not opening the menu up to allow me to set anything.

I go into develop apps, create device & paste D_Arduino1.xml in Upnp Device Filename field.

Thats fine device is created. At this point it is an "Unnamed device"

Then I go back to develop apps Serial port configuration & get this

ClickReload Luup & the device becomes

but i am still not able to choose serial port & if click start on the device I get
lua startup failure message

Cheers Jamie

[heeythere47]

Also have gone to z-wave settings & restarted luup engine. Thanks

[heeythere47]

I have come to the conclusion that my vera does not recognise theses nanos & have ordered what I hope is a genuine one by the price. I will see how that goes.
Cheers Jamie

[mjunqueira]

There is a cheaper version of the nano that uses the ch340 Usb to Serial, there is no driver on the open wrt, to recognize it,

Please take a look at the bottom of your nano,

if it´s the same of to photo, you will need to buy one with the FTDI chip:

[heeythere47]

Hi,
that is the chip on the nanos I bought. The serial gateway is working now I received a genuine nano & the cheap ones work fine with relays, motion sensors etc. All good.
Thanks Jamie