IR node

[skatun]

Hi
I have connected my IR node to my serial gateway, however I have a wish that my controller(Opnehab on RPI) can send out NEC,xxxxxx to my gateway which then forwards it to the node. This way I do not need to recompile my node everytime I want to add a new IR command. Is it possible to achieve this? I had a glance at the IR code provided here:

void incomingMessage(const MyMessage &message) {
  // We only expect one type of message from controller. But we better check anyway.
  if (message.type==V_LIGHT) {
     int incomingRelayStatus = message.getInt();
     if (incomingRelayStatus == 1) {
      irsend.send(NEC, 0x2AA22DD, 32); // Vol up yamaha ysp-900
     } else {
      irsend.send(NEC, 0x1EE1F807, 32); // Vol down yamaha ysp-900
     }
     // Start receiving ir again...
    irrecv.enableIRIn(); 
  }
}

How has other people implemented IR commands?

[mfalkvidd]

There are several threads on IR in the forum. https://forum.mysensors.org/topic/2413/ir-record-and-playback-module Is probably a good starting point.

[skatun]

@mfalkvidd , Thanks for the tip:) I saw some other IR codes in the forum, but @BartE code seems the most promissing. Do you think I can modify his code to achieve what I want?

On OpenHab which I use as controller I will then send something similiar to this then when I want(single button in OH): to turn on my TV, select correct input source on my stereo, select correct hdmi channel:

12;7;1;1;32;NEC,0xa8bca
12;7;1;1;32;NEC,0xa54bca
12;7;1;1;32;NEC,0xa62ca

[CrankyCoder]

Has anyone done any testing with having your IR codes stored at the controller?

A while back I had played with having my IR codes stored on the controller in a mapping file so I wouldn't have to recode my IR blaster each time I wanted a new IR code added.

However, this was all done with my blaster being over network not RF.

Has anyone done anything with this type of setup over the mysensors RF?

[martinhjelmare]

@Jason-Brunk

It's now possible in home-assistant.

https://forum.mysensors.org/topic/3917/an-hass-service-to-send-messages-to-nodes/7

[mfalkvidd]

@Jason-Brunk said:

Has anyone done any testing with having your IR codes stored at the controller?

Yes. See the link I posted above your post.

[CrankyCoder]

Thanks! The looks alot like what I did with my non-mysensors stuff. So that is perfect!!