Powering mote 24/7 using only a supercap and solar
-
These look quite inexpensive:
https://www.aliexpress.com/item/30-x-ultra-capacitor-2-7v3f/32570929215.html?spm=2114.10010108.1000023.15.qq5cZ7 -
These look quite inexpensive:
https://www.aliexpress.com/item/30-x-ultra-capacitor-2-7v3f/32570929215.html?spm=2114.10010108.1000023.15.qq5cZ7 -
@NeverDie indeed. but 2.7 Volt is a just a bit of a difficult value to work with and putting them in series makes the capacity drop, but I think one could run the attiny 13-25-45-85 from 1.8V so that might be a good combo
Or, maybe this then:
https://www.aliexpress.com/item/Universal-Capacitors-Ultracapacitors-2-7V10F-super-capacitor-10F-2-7V-low-ESR-fast-charging-small-power/32688216790.html?spm=2114.10010108.1000013.4.G3WV1v&traffic_analysisId=recommend_2088_2_81019_new2&scm=1007.13339.81019.0&pvid=1ecf1af6-9158-4f9f-99ff-acaa16690ce2&tpp=1
It's just a wild card as to whether they actually perform according to the advertised specs, though. That's why I think it's helpful if we all share what we're actually using, and whether it meets expectations or not. -
@NeverDie indeed. but 2.7 Volt is a just a bit of a difficult value to work with and putting them in series makes the capacity drop, but I think one could run the attiny 13-25-45-85 from 1.8V so that might be a good combo
@Ed1500 said in Powering mote 24/7 using only a supercap and solar:
@NeverDie indeed. but 2.7 Volt is a just a bit of a difficult value to work with and putting them in series makes the capacity drop, but I think one could run the attiny 13-25-45-85 from 1.8V so that might be a good combo
Yeah, and the RFM69--which is what I use--runs as low as 1.8v as well, so it's possibly a good match.
-
Or, maybe this then:
https://www.aliexpress.com/item/Universal-Capacitors-Ultracapacitors-2-7V10F-super-capacitor-10F-2-7V-low-ESR-fast-charging-small-power/32688216790.html?spm=2114.10010108.1000013.4.G3WV1v&traffic_analysisId=recommend_2088_2_81019_new2&scm=1007.13339.81019.0&pvid=1ecf1af6-9158-4f9f-99ff-acaa16690ce2&tpp=1
It's just a wild card as to whether they actually perform according to the advertised specs, though. That's why I think it's helpful if we all share what we're actually using, and whether it meets expectations or not.@NeverDie 10F now we are talking. But yes I very well understood yr request to share experience. I acn only say thet the 1.5 F's i had performed well and with an RC network thrown together, they seemed in the right ballparc... but apparently seller now sells 1F and I cant vouch for those
The supercap is still a very viable alternative for smaller devices, so I will probably buy more in future and thus interested in which ones are good or not
-
@Ed1500 said in Powering mote 24/7 using only a supercap and solar:
@NeverDie indeed. but 2.7 Volt is a just a bit of a difficult value to work with and putting them in series makes the capacity drop, but I think one could run the attiny 13-25-45-85 from 1.8V so that might be a good combo
Yeah, and the RFM69--which is what I use--runs as low as 1.8v as well, so it's possibly a good match.
-
@NeverDie ah yes it does, but the RFM is usually connected to a microcontroller :-) So that is limited choice
i wonder if 1.8 Volt would seriously affect the range of the RFM69 (running mine from 3.3)@Ed1500 said in Powering mote 24/7 using only a supercap and solar:
@NeverDie ah yes it does, but the RFM is usually connected to a microcontroller :-) So that is limited choice
i wonder if 1.8 Volt would seriously affect the range of the RFM69 (running mine from 3.3)Interestingly enough, the lower voltage doesn't seem to affect the range.
ATmega328p's can run at 1.8v also. In theory it should be set to run at 4mhz, but neither I nor anyone I know of has had problems running at 8Mhz down to 1.8v. If you run with BOD off and internal 8Mhz resonator, it only consumes about 150na while sleeping. That's why I haven't bothered going to ATtiny's. Maybe there are other reasons to do so though?
-
So, I just ordered this:
https://www.aliexpress.com/item/3PCS-fala-capacitor-2-7v10f-super-capacitor-high-current-Low-ESR-fast-delivery-2-7V10F-ultra/32715563451.html?spm=2114.13010608.0.0.qFbHqn
and this:
https://www.aliexpress.com/item/CNIKESIN-2PCS-Fala-Capacitor-2-7v10F-Super-Capacitor-High-Current-Low-ESR-Fast-Delivery-2-7V10F/32804681189.html?spm=2114.13010608.0.0.qFbHqnfrom the same seller that gohan used. It's a risk, but if either of them check out, I may buy more of that brand.
I'll make a posting after I receive them to say whether they seem to be good or not. :)
-
I recently purchased one of these:
https://www.aliexpress.com/item/Mega328-Transistor-Tester-Diode-Triode-Capacitance-ESR-Meter-MOS-PNP-NPN-M328/32685741297.html?spm=2114.01010208.3.92.KtC8xSand, for the price, it seems to do a decent job of measuring capacitance and ESR.
-
@Ed1500 said in Powering mote 24/7 using only a supercap and solar:
@NeverDie ah yes it does, but the RFM is usually connected to a microcontroller :-) So that is limited choice
i wonder if 1.8 Volt would seriously affect the range of the RFM69 (running mine from 3.3)Interestingly enough, the lower voltage doesn't seem to affect the range.
ATmega328p's can run at 1.8v also. In theory it should be set to run at 4mhz, but neither I nor anyone I know of has had problems running at 8Mhz down to 1.8v. If you run with BOD off and internal 8Mhz resonator, it only consumes about 150na while sleeping. That's why I haven't bothered going to ATtiny's. Maybe there are other reasons to do so though?
@NeverDie I have used Attiny's mainly for their size. Pricewise, compared to a pro mini clone it is a bit foolish, unless you use the smd versions.
I had an attiny+ 433Mhz transmitter built in one of those garden lamps with a moisture sensor at the base where it sticks in the soil. Worked well, Not ideal, but it was nice to play around with -
I recently purchased one of these:
https://www.aliexpress.com/item/Mega328-Transistor-Tester-Diode-Triode-Capacitance-ESR-Meter-MOS-PNP-NPN-M328/32685741297.html?spm=2114.01010208.3.92.KtC8xSand, for the price, it seems to do a decent job of measuring capacitance and ESR.
-
@Ed1500 I got the bigger brother of that one. Look at the workshop discussion. I can't wait to start testing this stuff with all the voltage regulators I got and see how much energy I can actually store in the same 2 caps both in series and parallel
-
@Ed1500 I got the bigger brother of that one. Look at the workshop discussion. I can't wait to start testing this stuff with all the voltage regulators I got and see how much energy I can actually store in the same 2 caps both in series and parallel
-
@Ed1500 I got the bigger brother of that one. Look at the workshop discussion. I can't wait to start testing this stuff with all the voltage regulators I got and see how much energy I can actually store in the same 2 caps both in series and parallel
@gohan said in Powering mote 24/7 using only a supercap and solar:
Look at the workshop discussion.
Uh, what workshop discussion would that be?
-
@gohan said in Powering mote 24/7 using only a supercap and solar:
Well, after much digging, I think I finally found your post. Is this what you're referring to?
Is it better than the one I posted?
I'm thinking of possibly getting one of these:
http://www.ebay.com/itm/261114892135
if only because the company that makes it also makes a popular low budget signal generator.I don't know that I actually need it though, except to verify that stuff purchased from Aliexpress actually is what it purports to be. :grinning:
-
If anyone interested for some ideas of supercaps protection https://youtu.be/NsTAyD2i3rc
@gohan said in Powering mote 24/7 using only a supercap and solar:
If anyone interested for some ideas of supercaps protection https://youtu.be/NsTAyD2i3rc
Useful video if connecting capacitors in series. If using just one capacitor, though, I wonder whether there's any advantage to using the described shunt regulator circuit compared to simply using a 2.7v LDO voltage regulator?
By the way, if your supercap's will be in a higher than room temperature environment, you may have to de-rate their max voltage. In general, supercaps won't last as long at high temperatures. Worth checking the datasheet for the details if that's a possible concern.
