Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Gas meter sensor

nikos1671 last edited by

Hi,
I am trying to build my first sensor a gas meter sensor. My hardware,arduino nano and a reed sensor.
Can someone share his sketch?

Thanks
Nikos
Reply Quote 0
1 Reply Last reply
mfalkvidd Mod last edited by @nikos1671

@nikos1671 it depends a bit on which type of gas meter you have, but these threads have some recommendations
https://forum.mysensors.org/topic/2571/support-for-gas-meter
https://forum.mysensors.org/topic/5812/counter-pulse-for-gas-meter
https://forum.mysensors.org/topic/4740/gas-meter-monitoring-with-optical-sensor
https://forum.mysensors.org/topic/6125/gas-meter-reading-using-a-magnetometer
Reply Quote 0
1 Reply Last reply
nikos1671 last edited by nikos1671

My gas meter is with magnet
Reply Quote 0
1 Reply Last reply

3
Posts

1956
Views

Log in to reply

Suggested Topics

Arduino Celebrates 10 years (Malmö/Sweden)
Announcements • • hek

1

0
Votes

1
Posts

3307
Views

No one has replied
Gateway without a radio
Development • • OldSurferDude

3

0
Votes

3
Posts

24
Views

@OldSurferDude yes, just run the configure command with --my-transport=none
Counting Incoming and Outgoing Messages from a Gateway
Development • • Trand

3

1
Votes

3
Posts

24
Views

@mfalkvidd Thank you very much, that's exactly what I was looking for!
Serial Gateway woes
Development • • OldSurferDude

1

0
Votes

1
Posts

10
Views

No one has replied
LAN8720A - will mysensors work with this module
Development • • Marcin

3

0
Votes

3
Posts

20
Views

Thanks for the answer. I meant that Mysensors has ESP32 support but only in terms of WIFI. It supports e.g. stm32 with ENC or W5500 modules - and the question is whether and how to add ESP32 support with LAN8720 module. I am not considering using ESPHOME or MQTT - I want to have native communication with the controller that implements my control schemes on its side. I try to program KC868-A16 but it does not matter - the question is whether such support can be added in a simple way.
Saving last known good state, but not in EEPROM
Development • • OldSurferDude

6

0
Votes

6
Posts

32
Views

@OldSurferDude jus request counter states from controller on each reset, worked fine with Domoticz... or save in eeprom but increase location every write, on power up/reset search eeprom for largest value stored and carry on from that location, one long integer will fit 256 times in atmega328(p) eeprom, is that long enough for you ?

44
Online

11.5k
Users

11.1k
Topics

112.7k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1