Problem with ethernet gateway
After many hours with my ethernet gateway I give up and ask for help
when I starting the gateway the serial monitor state '0;0;3;0;14;Gateway startup complete.' but I cant ping to the gateway address.
I try different ethernet sketch to eliminate hardware problem and all of them works good.
what else can I check?
working with 1.4 library on windows 7 OS with 1.0.6 IDE
Is only ping a problem or can't you even connect to it?
oded00 last edited by oded00
From Vera side I get 'MySensors plugin : Cannot send command - communications error'
telnet to 5003 port responds connect failed
Ok.. then you got more than a ping problem.
First, you have to tell us which ethernet module you use...
Did you enabled SOFT-SPI for radio?
The ethernet module is wiznet 5100
softspi is enable in RF24_config.h
I guess im not the only one with this problem
Dean last edited by
I had the same problem, I asked for help but no one seemed to know what the problem was. After following the above link and changing the sketch as suggested, it looks like it all is working!