Error when communicating with EasyIot



  • Hello ,
    I have trouble to get the correct communication when communicating with EasyIoT.
    This is what ise on my Arduino (Mini pro) when debug is on.
    I need some help to understand protocol it does not match what is described in MySensors serial 1.4.
    sensor started, id 5
    send: 5-5-0-0 s=255,c=0,t=17,pt=0,l=5,st=fail:1.4.1
    send: 5-5-0-0 s=255,c=3,t=6,pt=1,l=1,st=fail:0
    send: 5-5-0-0 s=255,c=3,t=11,pt=0,l=13,st=fail:Temp,Door,Bat
    send: 5-5-0-0 s=255,c=3,t=12,pt=0,l=3,st=fail:1.0
    send: 5-5-0-0 s=0,c=0,t=6,pt=0,l=5,st=fail:1.4.1
    send: 5-5-0-0 s=1,c=0,t=0,pt=0,l=5,st=fail:1.4.1
    Door = 0
    send: 5-5-0-0 s=1,c=1,t=16,pt=2,l=2,st=fail:0
    send: 5-5-255-255 s=255,c=3,t=7,pt=0,l=0,st=fail:
    batLevel = 100
    send: 5-5-0-0 s=255,c=3,t=0,pt=1,l=1,st=fail:100
    Temp = 21.10
    send: 5-5-0-0 s=0,c=1,t=0,pt=7,l=5,st=fail:21.1
    LOOP = 1
    Door = 0
    send: 5-5-0-0 s=1,c=1,t=16,pt=2,l=2,st=fail:0

    Regards sigolhi



  • I had a similar issue, but now EasyIoT is working with a test sensor well.

    Have you set both the pi gateway and the arduino to the same radio channel?

    That one got me scratching my head for a while! 🙂

    Skywatch.



  • @sigolhi Almost the same problem here.
    See the forum topic: http://iot-playground.com/forum/mysensors-driver/43-configuring-mysensor-nodes
    Unfortunately no solution yet..



  • @pvoj It shoud work. It works for me and other users also reports it works.


Log in to reply
 

Suggested Topics

  • 3
  • 14
  • 4
  • 3
  • 3
  • 2
  • 3

167
Online

10.4k
Users

10.7k
Topics

110.0k
Posts