Topics created by Christian Simonsen

@alexsh1 Hi Alex, I tested the Sanity check on the the Arduino sensor node, and status came back OK. However I could get this to work on the Raspberry Pi, seems like this function is not yet supported. At least I couldn't find any info on it using the "./configuration -h". I don't have a AMS1117 available so I can test that. I connected my Arduino Nano and NRF24L01+ to the Raspberry Pi via USB, that would really well. So I might just use this solution instead as I see little benefit of connecting the NRF24L01 directly to the GPIO pins on the Raspberry Pi. Next step is to start building some battery powered sensors that I can use, and get MyController setup properly.

This isn't working at all. First, yes you have fake chips, I have the same ones, but they work with the RF24 library just fine so far. Second, the payload should be either the current microseconds or a steadily incrementing number. The payload you're getting is the result of either bad power or incorrect pin out to your controller, usually the CE and CSN are wrong.

I am using Domoticz. It is very nice and Gizmocuz is very helpful and quick. You can install Homekit to it, nothing i have tried YET. https://www.domoticz.com/wiki/Homekit_Siri I am using Pilot as iPhone app and that is great, Patrick is listen to you if you have any ideas or question. https://itunes.apple.com/en/app/pilot-home-automation-control/id902546368?mt=8