@petewill

Hmm,
Okay, but I think I don't understand is how I will do the communication between getway ethernet and another device.

@andriej
I have a raspberry, but I think use only arudino.

@petewill

Hmm,Okay
I will try make a device type Vera because,in my country doesn't exists.
If I buy at site and ask to ship me Will cost very expensive, therefore I try make a device similar to vera
Could you help me?
Thx

Hmm,Okay
I willmake a ethernet getway, but I don't understand how I sync the sensr with her eheh

@petewill
mm, I will install one of these in my PC and I will buy a ethernet bord, and make a gateway ethernet.
But what I do not understand is How the Web Site will send a rf signal from arduino
Okay I know I should connect the ethernet bord in arduino and rf transmisor, but how do
sensor received this signal I know I will put rf receiver inside.
But the code of ethernet gateway doesn't have nothing about the transmissor.
If you don't understand something ask me.
Thx

Hello,

Someone know how a make a device type of Vera?
The Getway Ethnet replaces the Vera Device?

@petewill

Okay, I thought that you create a device smilar to Vera.
Because I thinking do this.
Do you have any ideia how I do this?
Thx

@petewill

Hello, how are you?
Man, I understood how you do this project, but Have one thing I doesn't understand, How you sync the plug with your cellphone?
Because intro the plug have a Arduino and RF Module.
Could you explain me?
Thx

Hello,
I'm doing the Ethernet getway, but I have a problem.
I would like adding a a button to sync the sensor.
Someone know how I do this?And of course add button in sensor to sync the devices.
Thx

@olaeke
I have a question for you
I will do a ethernet getway.
How i can sync this getway with "Smart Plug" Module?
There is a button to sync or I should use Vera?
Thx