@petewill

Hmm,
Okay, but I think I don't understand is how I will do the communication between getway ethernet and another device.

@andriej
I have a raspberry, but I think use only arudino.

@petewill

Hmm,Okay
I will try make a device type Vera because,in my country doesn't exists.
If I buy at site and ask to ship me Will cost very expensive, therefore I try make a device similar to vera :/
Could you help me?
Thx

Hmm,Okay
I willmake a ethernet getway, but I don't understand how I sync the sensr with her eheh

@petewill
mm, I will install one of these in my PC and I will buy a ethernet bord, and make a gateway ethernet.
But what I do not understand is How the Web Site will send a rf signal from arduino
Okay I know I should connect the ethernet bord in arduino and rf transmisor, but how do
sensor received this signal I know I will put rf receiver inside.
But the code of ethernet gateway doesn't have nothing about the transmissor.
If you don't understand something ask me.
Thx

Hello,

Someone know how a make a device type of Vera?
The Getway Ethnet replaces the Vera Device?

@petewill

Okay, I thought that you create a device smilar to Vera.
Because I thinking do this.
Do you have any ideia how I do this?
Thx

@petewill

Hello, how are you?
Man, I understood how you do this project, but Have one thing I doesn't understand, How you sync the plug with your cellphone?
Because intro the plug have a Arduino and RF Module.
Could you explain me?
Thx :)

Hello,
I'm doing the Ethernet getway, but I have a problem.
I would like adding a a button to sync the sensor.
Someone know how I do this?And of course add button in sensor to sync the devices.
Thx

@olaeke
I have a question for you :)
I will do a ethernet getway.
How i can sync this getway with "Smart Plug" Module?
There is a button to sync or I should use Vera?
Thx

@axillent
Okay, I will try :)
The sketch of the Plug, I will see that do many challenges, but let's go.
I was reading the code the Ethernet getway, but i learn how i sync it with another sensor.

Thx for your help

@axillent
You modified the code base, alright?
Could you send me the new code?
Thx

Okay, I understand
Sorry my silliness, but what do you mean hardcore 2?
I will do this sketch today(Ethernet Getway), but my big problem will do sync the getway to this sensor(Plug) or another sensor and control via web/cellphone
:/

Hmm, you use the ethernet gateway sketch:),

Okay,I will do the question again, because it was a bit confusing.

This getway control another things? For exemple "Smart Plug" Module?
If yes, how you control this Plug?

Thx

hey axillent,

Could you upload the source code of your gateway?
You use another slave that?(Type of This gateway send a RF to anther module and control de lamp?)
If Yes could you post the schema and de souce code?
Thx