I ran across this post while searching for a solution to the "Il faudrait une police plus petite1002stable" problem.
While the new json file has worked, I am not clear on how the different symbols and forecasts are incorporated into Vera, as mine continuously displays only the temperature icon with the pressure.
Is this something that has to be addressed within the arduino sketch?
Thanks...
@AWI Thanks. I have been using the Accelstepper library, but this has already given me several other ideas.
I appreciate the help.
@AWI Are you able to share the sketch you used with the UL2003 driver board? I have tried to combine the MySensors servo sketch with other arduino only sketches utilizing the UL2003, but without luck. Thanks.
Yes I did. As I mentioned in a couple of posts back, it is working now. Seemed to be solely a problem of skipping over pin D3. All of my previous attempts started on D4 and skipped over D3. Once I moved it back, it has been flawless. Thanks.
I am not sure either. I have always wired up D2 to the radio in case it is used in the future. All I know is once I moved the first relay from pin D4 to D3 and of course revised the sketch, it began to work perfectly every time.
Well I have seemed to figure it out. You evidently should not skip over any digital output pins on the arduino in the sketch. Once I moved the first relay to D3 (D2 is used by the radio), it has worked flawless. Unused pins after the used ones are okay. Hope it may help someone else out having similar problems.
I am having difficulty when running nodes with multiple relays (up to 4). The first relay (pin x) runs properly, but remaining relays (pin x+1, pin x+2, etc.) only pulse on for a half or second or so. Vera indicates it is still on, as well as the debug. An "OFF" command from Vera, causes it pulse again, while Vera and the debug report it off. Things I have tried include:
Anyone have any other ideas I can try....I am about out. Thanks.