@Thibthib02 Modify the arduino ide example sketch to work with mysensors and try it .

@axillent : thanks and @Tibus i think all only 45 and r4 would be like 0.5w else all 0.25 may be i have not worked much with smd tough.

@axillent i wanted some more information along with the schematics.. like the wattage of the resistors used and also the type and voltage rating of the capacitors . Please could you provide the same ?

@tbowmo : if the connections are fine when can we expect he board for production ?? looks everything is fine

@Wiebe-Nieuwenhuis said:

-lrf24-bcm

install the -lrf24-bcm library first and den run make here... u have a dir for lrf24 bcm install it before and u should not have this erro

i think V_DIMMER can be used for the purpose.. but controlling speed is not something u can do with just a relay .

@hek said:

In the receiving node you can pick it up just like the RelayActuator example does.

then would it automatically be cleared ? or we need to change the destination again to the gateway for normal operation ??

@ahhk mostly no i did not see mqtt der

@ahhk install the raspberry pi mysensor port on ur raspberry and run the make command. then u shd see get executable file generated which u can then open and this would work as a /dev/tty* serial port .

@Anticimex really a cool thing i just wanted to know if the rasp pi version of the mysensors will also get this ? it will be very useful when we use the raspberry pi as the gateway using pigateway serial.