My First version of curtain control Node is ready, installed and tested. Some work is pending, which I'll complete on my weekend.
Edit: Code for the Node:Curtain Node
Curtain Control Node.
Please share your feedback so that I can improvise.
Best posts made by Suresh Mali
-
Curtain Control Node.posted in My Project
-
RE: I am not able to stop the blinds motor once the first command is sent.posted in Troubleshooting
@mfalkvidd Thanks for your suggestion. It works great.
-
RE: Over the air (OTA) bootloading update tutorial?posted in General Discussion
Can I use i2c EEPROM for OTA bootloading with DualOptiboot or it has to be Serial SPI. I was not able to find any documentation on it. I brought a breakout board and it seems to be i2c, and i2c chips are easily available where I live.
-
RE: Curtain Control Node.posted in My Project
Its a Geared DC Motor with Voltage Rating of 6-12V and 100 RPM. I am using a L239 to control the motor.
-
RE: [Resolved] accept: Bad file descriptorposted in Troubleshooting
Thanks @mfalkvidd and @gohan . That helped.
-
RE: Over the air (OTA) bootloading update tutorial?posted in General Discussion
@ahmedadelhosni Hey, I found this article. Seems like the guy has used i2c for remote flash. I was not able to extactly understand whats going on, maybe you can help.
http://www.rotwang.co.uk/projects/bootloader.html
-
RE: Curtain Control Node.posted in My Project
@franzelare Great. Good Luck with the build.
I'll be posting my HW design and Code as part of Contest on openhardware.io